Management-system certificates and registrations held by Sagiant Piping Industries, with the scope, issuer and dates exactly as printed on each document — and the inspection documents that are issued per order.
SAGIANT
/ Certificates
Certificates and registrations
Details transcribed from the PDF copies on this site. Status reviewed 24 October 2026.
ISO 9001:2015 — Quality management system
Certificate of Registration · AMCERT (UK), issued by International Certificate & Inspection UK Limited
Certificate no.
QMS1805W
Certified
20 August 2024
Surveillance audits
Due 19 August 2025 and 19 August 2026
Expiry
19 August 2027, subject to maintaining the system
Sites
Registered office, Grant Road, Mumbai; factory, Dapode Village, Bhiwandi
Scope
Manufacturers and exporters of pipes, tubes, buttweld pipe fittings, forged fittings and flanges in stainless steel, alloy steel and nickel alloy; metal fire door and metal fabricators; clean room, HVAC and ducting.
To confirm: the 19 Aug 2026 surveillance outcome is not shown on this copy
Certificate of Compliance — PED 2014/68/EU & Machinery Directive 2006/42/EC
Issued by AMCERT (UK) for the quality system covering design, manufacture and final inspection
Certificate no.
CE1802W
Issued
20 August 2024 (initial registration 20 August 2024)
Re-certification
19 August 2026
Expiry
19 August 2027
Scope
As for the ISO certificates above.
Conditions
Applies to the quality system only and does not replace design or type-examination procedures; based on evaluation of one sample.
The document does not show an EU notified-body number. Where an order needs PED conformity assessment by a notified body (category II and above) or CE marking, state it in the RFQ so the applicable route and certificates are confirmed before order.
To confirm: re-certification date of 19 Aug 2026 has passed
The ISO certificates state that validity can be checked at www.amcert.in. Current copies are available on request with any quotation.
/ Documentation
Documents issued per order
Material test certificates to EN 10204 type 3.1, or 3.2 where a third-party or purchaser's representative validates the tests.
Heat-number traceability from certificate to product marking.
Dimensional and visual inspection reports against the product standard or drawing.
PMI, hardness, impact, IGC and NDE reports where the specification or order calls for them.
Packing list and marking details for dispatch.
These documents are specific to each order and are agreed at quotation stage.
/ Inspection
Third-party inspection
Third-party inspection is arranged on request through an agency named by the purchaser or agreed in the order. Inspection stages, hold points and witness requirements are taken from the purchaser's inspection and test plan.
Third-party inspection is a service coordinated per order; it is not a company certification.
